Model DC 4500E                                                                      To Dust Collectors >

Specs

Length
Width
Height


Height


Weight


Horsepower
Voltage

Full load Amp


8’-6”
4’-10”
7’-11” (Shipping position)
11’-5” (Working position)

2,500 lbs. (completely empty of dust)
15
460 VAC, 3 phase
18
4500E Electric Powered, Skid Mounted, 4500CFM Dust Collector

This 4500 CFM dust collector was designed by SAFE Systems to provide you maximum flexibility and reliability. Skid mounted, with both fork lift pockets and certified crane lifting eyes, the compact unit can easily be positioned in an optimum location. The extendable legs raise the unit to accommodate a 55 gallon drum or other collection device under the dust hopper and then adjust to allow low profile shipping. One (1) 18” duct connection makes connecting vent hose quick. A large, container-style door makes filter access easy.

Airflow through the dust collector can be regulated with the manually operated inlet damper.  Six (6) MERV 11 rated cartridge filters (MERV 15 rated filters are also available) collect the dust particles and are cleaned by a reverse pulse jet of 90 PSIG compressed air, one row of three (3) filters, at a time.  The dust particles removed from the filters fall into the hopper below that is equipped with a slide gate for quick and easy dumping of the dust into a waste container.

Belts and drives are eliminated by the direct-drive 15 HP motor. The NEMA 4 control box is dust and water tight to protect the electrical controls from contaminants and moisture. The unit comes with 25’ of the properly sized SO cord to allow electrical connection at the job site. One large, easy to open and close "Container Style" door gives quick access to the filters and dust hopper.
Picture
Click on Image to Enlarge >
Picture
Click on Image to Enlarge >
Features:
  • Skid mounted. 
  • Extendable legs. 
  • Forklift pockets for handling by a forklift. 
  • Certified lifting eyes for handling by overhead crane. 
  • Fan and dust collector rated for 4,500 CFM @ 12” WC. 
  • One (1) dust inlet, 18” diameter. 
  • Automatic reverse pulse cleaning system for filters. 
  • ¾” air piping for pulse cleaning system. 
  • Air requirements for pulse cleaning system, 30 CFM @ 90 to 100 PSIG. 
  • Fan is direct driven by a 15 HP, 460-volt, 3-phase electric motor. 
  • 460 volt AC control box. 
  • Six (6) MERV 11 rated cartridge filters, part # 1000 0300. 
  • Adjustable inlet damper on the fan for regulating the airflow. 
  • Slide Gate on the hopper dust discharge. 
  • Dust discharges into standard 55 gallon drum (drum supplied by customer) .
  • 25’ of properly sized SO cord for electrical hook-up.
Notes:
  1. Not intended to be shipped with any dust in collection hopper. 
  2. Recommend emptying dust every 2 to 4 hours depending on the dust collection rate. 
  3. It is recommended that a qualified electrician connect this equipment to power and check for correct motor rotation. 
  4. It is recommended that all new filters be coated with precoat dust (P/N 1416 0000) prior to putting into service.
  5. If operating this equipment using a generator, check with the generator provider to ensure proper sizing.  
  6. We recommend at least a 30 KW generator be used for this piece of equipment.
  7. We recommend shipping this piece of equipment on an open flat bed truck or trailer.  
  8. Shipping in an enclosed box van or trailer is not recommended.